Lanier R/C MARINER 40 MK II ARF Assembly Instructions Manual - Canopy Mounting Hardware
Assembly Instructions
Lanier R/C, INC. P.O. Box 458 Oakwood, Ga. 30566 PH 770 532 6401
© copyright 1989 Lanier R/C
18
18
Canopy Mounting Hardware
1. Phillips head metric screws
3mm x 20mm
2
2. Flat washers
2
Fuel tank
24 oz.
Gas stopper and line supplied
1
Decal Sheet
1
Instruction Booklet
1
Tool need to complete the
Stinger.
1. Drill and assorted bits
2. Hobby Knife with #11 blade
3. Masking Tape
4. T-pins or straight pins
5. Felt tipped pen/pencil
6. Rubbing alcohol
7. Paper towels
8. Phillips screwdriver
9. Allen wrenches
10. Metric tap 6mm.
11. Pliers (needle nose)
12. Mixing sticks
13. 36” yard stick or tape measure
14. Scissors
15. Moto tool with sanding drum.
Adhesives
1. Thin CA (cyanoacrylate) glue
2. Medium CA. Glue
3. CA remover/debonder
4. 5-Minute Zap Z-Epoxy
5. 30-Minute Zap Z-Epoxy
6. Zap Z-42 Threadlock
7. Zap Canopy glue.
Equipment Required
1. Four channel radio or better
2. Servos- 70in.oz. or better 9
3. 1200mah battery pack or larger
4. Y-connectors
3
5. 12” extensions (Aileron) 2
6. 24” extensions (Rudder) 2
(Elevators) 2
If you have a programmable radio that
will allow you to mix two channels to con-
trol the two elevator servos you will not
need a servo reverser. If not you will need
1 servo reverser, and one more Y-
Connector.
7. Heavy duty control arms to fit your
servos.
8. Switch harness (your radio)
9. Motor (gas or glow)
If gas , battery pack, and switch
for ignition.
10. Prop and 4” Spinner for your
motor.
11. Fuel line (for gas or glow)
12. Pilot figure (optional)
Throttle Hardware
1. E-Z connector
1
2. 12” 2-56 pushrod
1
3. 2-56 clevis
1
4. 2-56 nut
1
5. Lite-ply servo mount
1
6. 3/8” sq. x 3/4” spruce blocks 2