Lanier R/C MARINER 40 MK II ARF Assembly Instructions Manual - Cowl Mounting
Assembly Instructions
Lanier R/C, INC. P.O. Box 458 Oakwood, Ga. 30566 PH 770 532 6401
© copyright 1989 Lanier R/C
12
12
Cowl Mounting
Make the necessary cutouts in the cowl to
fit over the engine you have installed.
Slide the cowl in place so it overlaps the
fuselage at least 3/8” top and bottom.
Install the spinner back plate on your
engine and leave 1/8” gap between the
cowl and back plate. Tape the cowl in
place and drill a 1/16” pilot hole through
the cowl into the mounting blocks on each
side at the top.
Drill one hole in the center of the cowl
making sure it goes into the firewall.
Drill two screw holes on each side of the
cowl at the bottom again making sure they
go into the firewall and not just the fuse-
lage side. Secure the cowl in place using
the 3mm screws.
Locate the two shaped cowl mount blocks
and locate them on the top of the fuselage
flush with the front of the firewall.. Mark
around them and remover the covering.
Epoxy in place Drill four 3/32” holes and
pin to firewall using round toothpicks and
epoxy.
cowl mount blocks
drill and pin 4 spots