Lanier R/C MARINER 40 MK II ARF Assembly Instructions Manual - Wing Assembly
Assembly Instructions
Lanier R/C, INC. P.O. Box 458 Oakwood, Ga. 30566 PH 770 532 6401
© copyright 1989 Lanier R/C
4
4
Wing Assembly
Start with one wing panel. Locate the
aileron and trial fit them on the wing. You
will need to determine which aileron is the
left and which is the right by trial fitting.
Make sure all the hinges are aligned and
the aileron is flush with the wing tip. Now
locate the other aileron and wing panel and
fit the aileron. When you are satisfied with
the fit remove the ailerons and lay them
behind the wing in the correct position.
The pin style hinges work best if installed
in both wing and aileron at the same time.
Apply a drop of oil in the hinge.Use 30
minute epoxy to glue them in. A syringe
works great, if you don’t have one
use a 1/8” dowel or piece of 3/32” wire to
get the epoxy into the holes. With glue in
the holes, push the hinges in wing up to
the pin. Apply glue in the holes on the
aileron and slide aileron into place. Work
the aileron up and down several times and
the pin hinges will rotate into position.
Make sure you have a tight fit between the
wing trailing edge and aileron leading edge.
Set aside to dry and install the other
aileron.
Locate the dihedral brace.
Trial fit the brace into the slot with the
holes aligned with the holes in the wing.
Locate the two 3/8”x 1-3/8” dowels and
make a mark 1/2” in from one end. Using
an exacto knife, remove the covering
from the holes in the front of the wing.
Insert the dowel in the hole and through
the hole in the dihedral brace.
Now slide the other wing panel on the dihe-
dral braces and insert dowel in hole.
Both dowels should go completely through
the dihedral brace and leave 1/2” exposed.