Lanier R/C MARINER 40 MK II ARF Assembly Instructions Manual - page 6
Assembly Instructions
Lanier R/C, INC. P.O. Box 458 Oakwood, Ga. 30566 PH 770 532 6401
© copyright 1989 Lanier R/C
6
6
Remove stab and fin from fuselage and
using a razor blade, remove the covering
between the lines you just marked. Cut
about 1/8” inside your mark so bare wood
will not be exposed when glued in place.
Cut carefully and cut only the covering,
don’t cut the balsa underneath as this
would weaken the stab and fin.
remove covering
remove covering
Using 30 minute epoxy, glue the stab and
fin in place using the marks made earlier
to align. Use masking tape to hold in place
if necessary. Check alignment and allow
epoxy to cure.
Trial fit the elevators and rudder in place.
Apply glue in the hinge holes and insert
the hinges up to the pin as you did on the
wing. Work the surfaces back and forth
several time to make sure there are no
binds and check gap to make sure it is
tight.