Lanier R/C MARINER 40 MK II ARF Assembly Instructions Manual - Tail Wheel Bracket
Assembly Instructions
Lanier R/C, INC. P.O. Box 458 Oakwood, Ga. 30566 PH 770 532 6401
© copyright 1989 Lanier R/C
9
9
Install the axles in the pre-drilled holes in
the landing gear using the aircraft lock-
nuts. Be careful and don’t over torque the
bolts or they will break easily. Install one of
the 3/16” wheel collars on the axel approx-
imately 3/16” in from the landing gear.
This will space the wheel in the middle of
the wheel pant. Adjust later if necessary.
The wheel pant has a 1/2” hole in one
side that will fit over the inside nut on the
wheel pant. Slide the wheel pant and wheel
on at the same time and install the outside
3/16” wheel collar. You should file a flat
spot on the axel where the set screw for the
wheel collar fits. Screw the wheel pant to
the axel using the 3mmx20 screw into the
blind nut on the inside of the wheel pant.
Be sure and use thread lock compound on
the screw.
Tail Wheel Bracket
Assemble the tail wheel bracket by sliding
the tail wheel wire through the plastic
bracket and secure on top with the special
collar. Thread the tiller rod through the top
portion and secure with set screw . Screw
the nylon control horns on each end of the
tiller rod.
Bolt the tail wheel bracket in place using
the three 2mm screws. Install the tiller
bracket on the rudder using two 2mm
screws. Connect the springs between the
tiller arm on the rudder and the one on the
tail wheel arm. Install the wheel using the
3mm wheel collar.