Lanier R/C MARINER 40 MK II ARF Assembly Instructions Manual - Flying Wires
Assembly
Lanier R/C, INC. P.O. Box 458 Oakwood, Ga. 30566 PH 770 532 6401
© copyright 1989 Lanier R/C
7
7
Flying Wires
The flying wires are functional on the
Stinger
Stinger and must not be omitted. Locate
the 12 flying wire brackets and bend a 45
degree angle on the end even with the
notch. ( hardware may vary from what is
shown in the pictures).
Attach the brackets to the stab and fin
with six 2mm x 20mm screws and nuts.
Locate the pre-drilled holes in the stab and
fin by measuring down approximately 3-
1/4” from the top of the fin and approxi-
mately 1/2” in from the leading edge and
trailing edge. Press down the covering and
with a pin you should be able to locate the
hole. Remove the covering using a knife.
On the stab measure in approximately 5”
from the tip and approximately 1/2” in
from the leading and trailing edge.
brackets
Attach brackets to both top and bottom
of stab, and both sides of fin. Locate the
eight 2-mm rods, 2mm clevises, nylon
swing in keepers, and clevis retainer sili-
cone tubing. Screw the clevis approximate-
ly half way on the threads of the rod and
attach to the bracket on the fin.
. Insert the 90 degree bend into the brack-
et and attach the swing in keeper.
Install the other 3 wires on top in the
same manner. Be careful not to put pres-
sure on any of the surfaces, after all the
wires are installed we will adjust the ten-
sion.