Lantech LGS-2300-RPS User Manual - page 49
41
RSTP System Configuration interface
91B
6.6.2.2 STP Port Configuration
User can configure path cost and priority of every port.
1. Select the port in Port column.
1. Priority: Decide which port should be blocked by priority in LAN. Enter a number 0
through 240.
2. Path Cost: The cost of the path to the other bridge from this transmitting bridge at
the specified port. Enter a number 1 through 200000000.
3. AdmP2P: Some of the rapid state transactions that are possible within RSTP are
dependent upon whether the port concerned can only be connected to exactly one
other bridge (i.e. it is served by a point-to-point LAN segment), or can be
connected to two or more bridges (i.e. it is served by a shared medium LAN