Lantech LGS-2300-RPS User Manual - Appendix A- Command Sets
62
7B
Appendix A- Command Sets
32B
Commands Set List
Modes
Access Method
Prompt
Exit Method
About This Model
User EXEC
Begin a session with
your switch.
switch>
Enter logout or
quit.
The user commands
available at the user level
are a subset of those
available at the privileged
level.
Use this mode to
• Perform basic tests.
• Display system
information.
Privileged
EXEC
Enter the enable
command while in
user EXEC mode.
switch#
Enter disable to
exit.
The privileged command
is advance mode
Privileged this mode to
• Display advance
function status
• save configures
Global
configuration
Enter the configure
command while in
privileged EXEC mode.
switch(config)#
To exit to
privileged
EXEC mode,
enter exit or end
Use this mode to
configure
Parameters that apply to
your switch as a whole.
VLAN
database
Enter the vlan database
command while in
privileged EXEC mode.
switch(vlan)#
To exit to user
EXEC mode,
enter
Exit.
Use this mode to
configure
VLAN-specific
parameters.
Interface
configuration
Enter the interface
command (with a
specific interface) while
in global configuration
mode
switch(config-if)#
To exit to global
Configuration
mode, enter exit.
To exist to
privileged
EXEC mode or
end.
Use this mode to
configure
Parameters for the switch
and Ethernet ports.