Lantech LGS-2300-RPS User Manual - 6.8 Factory Default
58
The ACL only support single port and not support trunk group.
The maximum number of ACLs is also 5 for each port.
Command Attributes
Enable: An ACL can be enable per port.
Default Action: The action if no rules matched.
Action: An ACL can be permit or deny rule.
IP Address and Prefix Length: Include destination and source IP address.
Ex: source 192.168.16.1/24 means all frames that source IP address is 192.168.16.x
matched.
Access Control Configuration Interface
29B
6.8 Factory Default
Reset switch to default configuration. Click
ALL
to reset all configurations to the
default value or
PART
to reset all configuration except reserved IP, user name and
password.