Lantech LGS-2300-RPS User Manual - Lldp Commands Set
83
8021x system
sharekey
[ID]
Global
configuration
mode
Use the 802.1x system share
key global configuration
command to change the
shared key value.
switch(config)# 8021x system
sharekey 123456
49B
LLDP Commands Set
Lantech
Commands
Command
Level
Description
Default
Example
lldp [enable]
or
no lldp
Global
configuration
mode
Enable or disable LLDP
protocol.
Disable
switch(config)# lldp enable
or
switch(config)# no lldp
show lldp status
Privileged
EXEC
Show LLDP status.
switch# show lldp status
show lldp remote
Privileged
EXEC
Show LLDP remote table.
switch# show lldp remote
lldp-port [disable
|rx|tx|both]
Interface
configuration
mode
Use those commands to set
lldp port tx and rx mode.
Disable
switch(config)# interface
gigaethernet 1
switch(config-if)# lldp-port
disable
or
switch(config-if)# lldp-port rx
50B
ACL Commands Set
Lantech
Commands
Command
Level
Description
Defaults
Example
acl-port
[deny|permit]
or
no acl-port
Interface
configuration
mode
Use the acl-port interface
configuration command to
enable Access Control on a
port. The default action can be
Deny or Permit. Use the no
form of this command to return
the port to its default value
(disable).
Disable
switch(config)# interface
gigaethernet 1
switch(config-if)#
acl-port deny
or
switch(config-if)#
no acl-port