Mahr Millimar C 1200 Operating Instructions Manual - page 41
41
Mahr GmbH • Millimar C1200
Measurement
Display
Setup
System
Absolute mode
Customer calibration
Factory calibration
Factory Settings
Info
ü
6
3
q
p
Measurement
Display
Setup
System
Factory calibration
Enable
Factory standard calibration
Werksnormalkalibrierung
Customer calibration Reset
6
3
q
p
Measurement
Display
Setup
System
Absolute mode
Customer calibration
Factory calibration
Factory Settings
Info
ü
6
3
q
p
6.3
Activate a Factory calibration
–
Press the ON / OFF key
=>
The
standard menu will appear on
the screen
–
Press the u key to select the
System
menu
–
Select the submenu
Customer
calibration with the q key
– Press
4
to confirm
–
Press the q key to select
Enable
– Press 4 to confirm or press Ó to
cancel selection
=> The
symbol 4 depicts the currently
active correction
–
To exit the input menu, press the ON /
OFF key.
To avoid any measurement errors that may be caused by previously created customer
calibration, it is advisable to implement the factory standard calibration. This constant
is stored in the measuring instrument and calibration functions cannot be altered by the
customer.