NorthStar 951X Installation Manual - Section One - Introduction
SECTION ONE - Introduction
951/952 INSTALLATION MANUAL Revision B
Page 1
SECTION ONE - Introduction
Welcome
T
he Northstar 951/952 Installation Manual describes how to install,
interface, and troubleshoot the Northstar 951 and 952 GPS chart naviga-
tors. Also described are the physical, mechanical, and electrical character-
istics of each unit.
For complete details about operating the unit, see the Northstar 951/952
Operator’s Manual (part number GM1500C).
The terms “unit” and “951/952” are used throughout this manual to refer
to both the 951 and 952 GPS chart navigators. The 952 features a color
display, but is otherwise identical to the 951, except where noted. The
951X and 952X are both differential-ready so you can interface them to
an external differential receiver. The 951XD and 952XD have built-in dif-
ferential receivers. Unless specifically indicated, all information in this
manual refers to both the X (non-differential)and XD (differential) ver-
sions of the unit.
Who should read this manual
The Northstar 951/952 Installation Manual is intended for marine techni-
cians who are configuring and installing either 951 or 952 GPS chart nav-
igators.
Scope of this manual
In this manual, you’ll find information about the following:
•
mounting and wiring the unit
•
installing the antenna
•
testing and troubleshooting the unit
•
configuring the NMEA output ports
•
configuring the RS-232 port
•
connecting two units to share waypoints and routes
•
technical specifications
The rest of this particular chapter explains how to obtain technical sup-
port and how to return a unit for factory service.
Getting technical support
After you’ve followed the instructions in this installation guide, if you
need additional technical support or have any other service-related ques-
tions, you can contact either your dealer or the Northstar Service Depart-
ment. Northstar’s Service Department can be reached by email, fax, U.S.