NorthStar 951X Installation Manual - page 64
SECTION THREE - Interfacing
Page 54
951/952 INSTALLATION MANUAL Revision B
data output to be received by the unit. Port 1 or Port 2 of the unit, or A or
B of the 800, may be used. Wire colors refer to the unit’s interface cable.
To configure the Northstar 800 for correct output format, execute COM-
MAND 83 for output port A, or COMMAND 84 for output port B. Press the
lower SELECT button until PRINTER 3 appears in the lower display, and
press ENT. Then enter the following sequence to program the output
parameters:
* Only used if you want the waypoint to which you’re navigating to be
automatically transferred to the unit’s waypoint database.
For further details, you may want to refer to the Northstar 800/800X Ref-
erence Manual (Part Number GM260).
Table 8: Connection to Northstar 800 port A
800 OUTPUT
Ý
Ý
Ý
Ý CONNECT TO EITHER Þ
Þ
Þ
Þ
Port A
951/952 Port 1
951/952 Port 2
Pin 12
brown (#3)
white with brown stripe (#6)
Pin N
blue (#1)
brown with white stripe (#2)
Table 9: Connection to Northstar 800 port B
800 OUTPUT
Ý
Ý
Ý
Ý CONNECT TO EITHER Þ
Þ
Þ
Þ
Port B
951/952 Port 1
951/952 Port 2
Pin 7
brown (#3)
white with brown stripe (#6)
Pin H
blue (#1)
brown with white stripe (#2)
Table 10: Northstar 800 series output port setup
At this prompt
Press
To output this data to the 951/952
SET UP
149 (ENT)
0183 output format
(8 bits, no parity, 4800 baud)
INTERVAL
1 (ENT)
1 second output rate
ITEM 1
13 (ENT)
include GTD sentence in output
(Loran-C TDs)
ITEM 2
26 (ENT)
waypoint location*
ITEM 3
31 (ENT)
include SRS sentence in output
(status of received signals)
ITEM 4
40 (ENT)
include RMA sentence in output
ITEM 5
0 (ENT)
end of sequence