NorthStar 951X Installation Manual - page 67
SECTION THREE - Interfacing
951/952 INSTALLATION MANUAL Revision B
Page 57
Instead, you must clear the anchor alarm in either of the following two
ways.
Option #1:
1. Press the
key once to display the ALARMS screen, then press
the
menu key.
Option #2:
1. Press the
key once to display the ALARMS screen.
2. Press the
to highlight the HONK OUTPUT option, then
press the
menu key.
3. Press the
to select either 200 PPNM (used to interface
to speed log devices), or ALL ALARMS, instead of ANCHOR ALM, then
press the
key.
Honking for all
alarms
Instead of setting all alarms to beep only, you can set all alarms to honk.
This honking starts simultaneously with the flashing exclamation point
on the ALARMS screen (952) or ALARMS & BACKLIGHT screen (951). After
you set all alarms to honk, the system emits an output sound for half a
second, followed by silence for half a second. This repeatable honking
sequence stops when the alarms either automatically clear or you manu-
ally clear them.
To set all alarms to honk:
1. Press the
key once to display the ALARMS screen (952) or
ALARMS & BACKLIGHT screen (951).
2. Press the
to highlight the HONK OUTPUT option, then
press the
menu key.
3. Press the
to select ALL ALARMS, then press the
key.
Table 12 below describes how to set the anchor-watch alarm and all other
alarms to the desired audio.
NOTE:
If you want all alarms to honk, you must first set the
ALARM
AUDIO
option to
ON.
Table 12: Beep and honk settings for all alarms
Sound
Type
Setting(s)
Description
Beep
All alarms
Set alarm audio field to ON
The unit’s standard alarm beep.
Beep
Anchor watch
Set alarm audio field to ON
Set anchor alarm field to ON
The unit’s standard alarm beep.