NorthStar 951X Installation Manual - page 32
SECTION TWO - Installing the unit
Page 22
951/952 INSTALLATION MANUAL Revision B
Mounting the AN205-P antenna
1. Strip cable jacket to the following dimensions (in inches), as illus-
trated in Figure 13: ”Stripping the coax cable jacket,” below: a=0.57,
b=0.34, c=0.14, d=0.43. Do not nick the center conductor.
Figure 13: Stripping the coax cable jacket
2. Figure 14: ”Flared cable braid,” below: Slide outer ferrule on as
shown. Slightly flare the end of cable braid, as shown, to facilitate
insertion into inner ferrule.
Figure 14: Flared cable braid
3. Place center contact onto center conductor so that it butts against
the cable dielectric. Crimp the contact in place using Amphenol tool
handle #227-944 and Cavity B of Die Set 227-980-3.
4. Install cable assembly into body assembly so inner ferrule slides over
dielectric and under braid. Push cable assembly forward until con-
tact seats in insulator. Slide outer ferrule over braid and up against
connector body. Crimp outer ferrule using Cavity A of tools specified
above. The connector ferrule-to-cable junction can be sealed and
protected using adhesive-lined heat shrink.
Figure 15: Completed TNC connector