Oce im2330 Printing Manual - Repairing Client Software

2 Installing Client Software for Windows

122    Repairing Client Software

Repairing Client Software

When the client software will not work correctly, you can repair the client software.

Repairing Client Utilities Software

The following describes an installation on Windows XP.  The procedure is the same when other 

versions of Windows are used.

y

Do not perform preparing the client software on Windows XP that the Service Pack 2 is not 

installed.  In that case, uninstall the client software and then install again to repair the client 

software.

y

Before repairing the software, please make sure you exit Document Monitor.

1

Insert the Client Utilities CD-ROM into the CD-ROM drive.

y

If the installer does not automatically start, double-click “Setup.exe” in the Client Utili-

ties CD-ROM.

2

Select “Repair” and click [Next].

y

Repairing files starts.

If the printer drivers and N/W-Fax driver are installed, the Select Port screen is displayed.  

If this screen is displayed, select “Local Port” and select the port for the printer drivers if 

printer drivers were installed.  If this screen is displayed, specify the network path or 

queue name and click [Next].