Oce im2330 Printing Manual - page 278
6 Printing from Macintosh
276 Printing from Application on Mac OS X 10.2.4 to Mac OS X 10.4.x
— Finishing
In the Finishing menu, you can set destination, hole punching and stapling.
1) Destination
This selects the destination tray.
- Inner Tray — Select this when no finisher is installed.
- Tray 1 — Select this to route the output to the upper tray of the Finisher.
- Tray 2 — Select this to route the output to the lower tray of the Finisher.
- Job Separator Upper — Select this to route the output to the upper tray of the Job Sep-
arator.
- Job Separator Lower — Select this to route the output to the lower tray of the Job Sep-
arator.
y
For im4530 Sereis, “Tray 1” and “Tray 2” can be selected when the Hanging Finisher,
Finisher (Type A), Finisher (Type B), or Saddle Stitch Finisher are installed.
y
When the Finisher (Type B) is installed in the im4530 Series and stapling is enabled,
select “Tray 2”.
y
For im2830 Sereis, “Tray 1” and “Tray 2” can be selected when the Hanging Finisher is
installed, and “Tray 1” can be selected when the Saddle Stitch Finisher is installed.
y
When the optional Job Separator is installed, you can select “Job Separator Upper” and
“Job Separator Lower” instead of “Inner Tray”.
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off — Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left side for the
portrait document, or on the top for the landscape document.
1
2
3