Oce im2330 Printing Manual - page 255

Printing with Extended Print Functionality    253

3

If you want to add a margin space between facing pages, enter a 

width in the “Center Margin” field.

y

You can change the unit of the margin at the “Units” drop down box.

y

The center margin can be set from 0.000 inch to 0.500 inches in units of 0.01 inch 

when the unit is inch, and from 0.000 mm to 12.700 mm in units of 0.10 mm when the 

unit is mm.

The printed images will be reduced according to the margin setting.

4

If you want to add a margin on the outside edge, enter a width in the 

“Outer Margin” field.

y

You can change the unit of the margin at the “Units” drop down box.

y

The center margin can be set from 0.000 inch to 1.00 inches in units of 0.01 inch 

when the unit is inch, and from 0.000 mm to 25.40 mm in units of 0.10 mm when the 

unit is mm.

The printed images will be reduced according to the margin setting.

5

If you want to double staple the center, check the “Staple Down the 

Center” box.

“Staple Down the Center” is available only when the Saddle Stitch Finisher is installed 

and configured on the Configuration tab.

6

If you want to create a booklet that can be read from right to left, 

check the “Number Pages from Right to Left” box.