Oce im2330 Printing Manual - page 303
Printing from Application on Mac OS 8.6 to 9.x 301
- Job Separator Lower — Select this to route the output to the lower tray of the Job Sep-
arator.
y
For im4530 Sereis, “Tray 1” and “Tray 2” can be selected when the Hanging Finisher,
Finisher (Type A), Finisher (Type B), or Saddle Stitch Finisher are installed.
y
When the Finisher (Type B) is installed in the im4530 Series and stapling is enabled,
select “Tray 2”.
y
For im2830 Sereis, “Tray 1” and “Tray 2” can be selected when the Hanging Finisher is
installed, and “Tray 1” can be selected when the Saddle Stitch Finisher is installed.
y
When the optional Job Separator is installed, you can select “Job Separator Upper” and
“Job Separator Lower” instead of “Inner Tray”.
2) Hole Punch
This sets whether or not a print job is hole punched.
- Off — Select this to print without hole punches.
- Long Edge Punch without rotation — Select this to create holes on the left side for the
portrait document, or on the top for the landscape document.
- Short Edge Punch without rotation — Select this to create holes on the top for the por-
trait document, or on the right for the landscape document.
- Long Edge Punch with 180 degree rotation — Select this to create holes on the right
side for the portrait document, or on the bottom for the landscape document.
- Short Edge Punch with 180 degree rotation — Select this to create holes on the bot-
tom for the portrait document, or on the left for the landscape document.
This option cannot be selected if a hole punch unit is not installed.