Oce im2330 Printing Manual - page 63

Installing Client Software for SMB Printing    61

Installing Client Software for SMB Printing

This section describes how to set up the client software for SMB printing which is available for 

the local area network over TCP/IP.

There are three ways to set up the printer drivers for SMB printing:

y

Using the installer in the Client Utilities CD-ROM

When you insert the Client Utilities CD-ROM into your CD-ROM drive, the installer automati-

cally starts.  You can install printer drivers and other client software using the installer.  If you 

want to install printer drivers as well as other client software, this method is convenient.

 P.61 “Installation for SMB Printing Using the Installer”

y

Using Point and Print

You can install the printer driver by double-clicking network queues on the system.  By this 

method, printer drivers can be downloaded from the system so that the Client Utilities CD-

ROM is not required. However, other client software cannot be installed using this method.

 P.68 “Installation for SMB Printing by Point and Print”

y

Using Add Printer Wizard

When you want to install the printer drivers without connecting to the equipment using Point 

and Print, install the printer drivers using the Add Printer Wizard.

 P.72 “Installation for SMB Printing by Add Printer Wizard”

Before installing the printer driver for SMB printing, check with your system administrator to 

make sure of the following:

-

This equipment is connected to the network and turned on.

-

The TCP/IP setting is correct on this equipment and your computer.

Installation for SMB Printing Using the Installer

You can install the client software and set up the SMB printing using the installer in the Client 

Utilities CD-ROM.

It assumes using SMB printing in a small network.  If you can use the Windows NT 4.0, Windows 

2000, Windows XP, or Windows Server 2003 as a print server, it is recommended to set up for 

printing via Windows print server.  For further information about setting up printing via a Win-

dows print server, see the Network Administration Guide.

Installing the client software for SMB printing using the installer

The following describes an installation on Windows XP. The procedure is the same when other 

versions of Windows are used.

You must log into Windows as a user who has the “Administrators” or “Power Users” privilege 

when using Windows NT 4.0, Windows 2000, Windows XP, or Windows Server 2003.

1

Insert the Client Utilities CD-ROM into the CD-ROM drive.

y

The installer automatically starts and the Choose Setup Language dialog box 

appears.

y

If the installer does not automatically start, double-click “Setup.exe” in the Client Utili-

ties CD-ROM.