PS Audio Power Plant P300 Instructions Manual - page 2

A new PS Audio Fan Module - Bottom

Plate Kit 

These instructions.

A Fan Upgrade label for the back of

your P300.

The small gray plastic strip for the

oscillator board.

BEFORE you open the unit:

Are you sure it is FULLY UNPLUGGED?  

DID YOU TAKE THE TIME TO READ

THESE ENTIRE INSTRUCTIONS AT

LEAST ONCE BEFORE STARTING?

Turn the P300 upside down, with the feet

facing up.  Use your small screwdriver to

take out the 10 small Phillips head screws

on the bottom plate.  Save the screws.

NOTE

: 

You do not need to take off the screws

holding down the feet to the Bottom Cover.

After you take off the ten screws from the

bottom cover, carefully lift the Bottom

Cover straight off.  You may notice some

slight resistance.  The Oscillator Board in

the P300 is secured by a small, gray plas-

tic bracket on the inside of the bottom

cover. So, when you lift off the Bottom

Cover, the Oscillator Board may remain

attached to the bottom cover support.

Simply

keep lift-

ing the

Bottom

Cover

straight

up. 

Most

times,

the