PS Audio Power Plant P300 Instructions Manual - page 4

Great!  Simply leave it attached.  Make

sure it is fully seated in its socket by giv-

ing a little push DOWN on the top of the

Board.

INSTALL THE FAN PLUG.

On the new Fan Bottom Plate, there is a

white set of wires and a loose white plug.

This plug is inserted into a socket on the

main board of the P300.

There are two empty sockets on the P300

main board; both are located near the

transformers. One socket is located in the

center on the back edge of the board. 

Do

Not Plug the Fan Module into this Socket. 

The other socket is off to one side of the

back edge of the P300 main board. THIS

IS THE CORRECT PLUG.  Plug the fan

board into this socket.  

The socket and plug are keyed so they

will only fit in one direction. Press the plug

into until it snaps.

Install the New Fan Bottom Plate.

Now that you have plugged in the fan

wire, you can put the bottom panel back

on the P300.  The Fan goes toward the

FRONT of the P300 and the empty hole

and grill toward the rear of the P300.   

Before reinstalling the Bottom Plate,