PS Audio Power Plant P300 Instructions Manual - page 5
attach the new gray plastic strip to the top
of the oscillator board. The groove in this
support strip aligns with the edge of the
Oscillator Board.
Now the gray plastic strip is attached, via
the groove, to the top of the oscillator
board, in the approximate middle of the
board.
Remove the piece of tape on the gray
plastic piece, exposing the adhesive.
Carefully align the bottom cover with the
chassis, and press down on the bottom
cover so as to afix the adhesive to the
inside of the bottom plate.
The new bottom panel should line up just
like the former bottom panel. It should be
flush all around.
Loosely insert the ten small Phillips head
screws. Make sure the bottom cover is
seated and flush, then fully tighten the
screws.
Turn the P300 over and perform the fol-
lowing tests:
Plug the P300 into your source of
power
Turn on the P300 unit with the switch