PS Audio Power Plant P300 Instructions Manual - page 3
Oscillator Card will stay plugged into the
P300 Main Board. Sometimes, the
Oscillator Card stays attached to the
Bottom Cover Support.
IF THE OSCILLATOR CARD REMAINS
ATTACHED TO GRAY PLASTIC SUP-
PORT ON THE BOTTOM COVER
– Read
this Section Carefully:
Pull the Oscillator Board off the gray plas-
tic support. Be careful to touch the Board
only on it edges. You need to reinsert the
Oscillator Board into its socket on the
P300 main board.
The electronic components on the
Oscillator Board
MUST FACE
FORWARD
, toward the faceplate of the
P300.
DO NOT
insert the Oscillator
Board so that the electronic components
face the rear of the P300.
Insert the Oscillator Board into its socket
on the Main Board
STRAIGHT DOWN.
DO NOT ROCK THE CARD
back and
forth. Insert it STRAIGHT. The Board
must NOT be inserted at an angle.
IF THE OSCILLATOR CARD REMAINS
IN THE P300 ATTACHED TO THE MAIN
BOARD.