Q-See QC-SERIES Quick Start Manual - page 2
Connect the Devices
STEP 1
Connect to a Monitor or Television
STEP 2
Connect Mouse
Connecting a VGA PC Monitor
1. Plug the VGA cable into the port marked “VGA” on the back of the
NVR.
2. Plug the other end of the VGA cable into the similar port on the back
of the monitor.
3. Plug the monitor’s power cable into the surge protector.
Connecting a Television
1.
Connect the BNC-to-RCA cable to the “Video Out” port on
the back of the NVR.
2.
Plug the RCA end into the “Video In” port on the television.
3.
Plug the television’s power cable into a surge protector.
If you do not see an image, check the Imput setting on the TV.
Connecting a HDMI Television
(for NVRs equipped with an HDMI port)
1. Plug an HDMI cable into the “HDMI” port on the back of the NVR.
2. Plug the other end into the “HDMI” port on the television.
3. Plug the television’s power cable into a surge protector.
If you do not see an image, check the Imput setting on the TV.
STEP 3
Turning on the NVR
1. Connect the 12V power adapter to the NVR power port on the right
side of the NVR.
2. Connect the 48V power adapter to the power port on the left side
of the NVR next to the POE port.
The power supplies will be labelled and the power jacks will only
fit easily into the proper port.
4a
4a
11
22
33
4b
4b
OPTION A:
OPTION B:
OPTION C:
Plug the mouse into the port labled “USB” on the rear of
the NVR.
NOTE: We recommend reserving the USB port on the
front of the NVR for use in backing up video files.
3. Connect the power cables to the power adapters.
4a. Plug the power cables into a surge protector
b. If your model has a power switch on the rear panel, use it to turn on
the NVR.
You will hear a beep as the NVR powers up.