Qlogic 3200 Series User Manual - page 125
2–Configuring NIC
NIC TroubleShooting/Diagnostics
SN0054671-00 B
2-79
Diagnostic help commands, and command options available for each specific
protocol, are available by specifying -h to the protocol, as shown in
.
lists miscellaneous Windows diagnostics commands.
lists the Windows CLI diagnostic test commands. Note that while
running these tests, network traffic is interrupted.
Table 2-12. Windows QConvergeConsole CLI—Getting Help
Command
Description
-h
Print usage of a specific adapter type, and then exit
qaucli -pr nic -h
Print NIC protocol usage, and then exit
qaucli -pr fc -h
Print Fibre Channel and FCoE protocol usage, and then
exit
qaucli -pr iscsi -h
Print iSCSI protocol usage, and then exit
qaucli -npar -h
Print NPAR commands usage, and then exit
Table 2-13. Windows QConvergeConsole CLI—Miscellaneous
Commands
Command
Description
qaucli -v
Print version number, and then exit
qaucli -h
Print usage, and then exit
Table 2-14. Windows QConvergeConsole CLI—Diagnostic Test
Commands
Command
Description
-i
--interface
Specifies the interface type (NX_NIC,
NX_NIC1, and so on)
-a
--all
Perform all tests, regardless of default
-D
--default
Perform only the default test
-R
--CRegs
Test all control registers (default)