Qlogic 3200 Series User Manual - page 142
3–Configuring iSCSI
iSCSI Boot
3-8
SN0054671-00 B
4.
Start the system; press Ctrl+Q when the BIOS screen for the QLogic
Adapter opens.
The Fast!UTIL Options menu opens.
5.
Select
Configuration Settings
.
6.
Select
Host Adapter Settings
.
7.
Enable the
Host Adapter BIOS
.
8.
Press ESC to exit the Host Adapter Settings window.
9.
Select
iSCSI Boot Settings
.
10. Enable
iSCSI Boot
.
DHCP Boot Setup for iSCSI Boot (IPv4)
DHCP boot provides a method for the iSCSI initiator to acquire target parameters
from a DHCP server. To configure the DHCP server to support iSCSI boot, first
ensure that your DHCP server is set up.
iSCSI Boot Setup Using QCC CLI
Refer to the
QConvergeConsole CLI User’s Guide
for information.
Configuring iSCSI Boot using the QCC CLI
Refer to the
QConvergeConsole CLI User’s Guide
for information.
Configuring iSCSI Boot using Interactive QCC CLI
Refer to the
QConvergeConsole CLI User’s Guide
for information.
Configuring iSCSI Boot using Non-interactive QCC CLI
Refer to the
QConvergeConsole CLI User's Guide
, “iSCSI Noninteractive
Commands” section for information.
Configuring iSCSI DHCP Boot Options using QCC CLI
Refer to the
QConvergeConsole CLI User's Guide
, “iSCSI Noninteractive
Commands” section for information.
Configuring iSCSI DHCP Boot Options using Interactive QCC CLI
Refer to the
QConvergeConsole CLI User's Guide
for information.
Configuring iSCSI DHCP Boot Options using Non-interactive QCC CLI
Refer to the
QConvergeConsole CLI User's Guide
, “iSCSI Noninteractive
Commands” section for information.