Qlogic 3200 Series User Manual - page 138
3–Configuring iSCSI
iSCSI Initiator
3-4
SN0054671-00 B
e.
IP_Gateway [0.0.0.0]:
Press the ENTER key
to accept the
default.
f.
Enable IPv6 [off]
: Press the ENTER key
to accept the default.
9.
On the options menu that opens, select
3, Save changes and reset HBA (if
necessary)
.
10. At the prompt for both ports, type
Yes
.
11.
To return to the Converged Network Adapter (CNA) iSCSI Configuration
menu, type
p
and press the ENTER key, and then type
p
and press the
ENTER key again.
12. On the Converged Network Adapter (CNA) iSCSI Configuration
menu,
select
4, Target Configuration
.
13. Select the same Converged Network Port you selected in
14. Select
6,
Add a Target
.
15. Complete the interactive list of settings as follows:
a.
IPv6 Target? [off]:
Press the ENTER key to accept the default.
b.
TGT_iSCSI_Name []:
Type the iSCSI qualified name (IQN) of the
iSCSI target to connect to, and then press the ENTER key.
c.
TGT_Port [3260]:
Press the ENTER key
to accept the default.
d.
TGT_TargetIPAddress [0.0.0.0]:
Type the IP address of the
target, and then press the ENTER key.
16. On the options menu that opens, select
12, Save Target/CHAP Changes
.
The iSCSI initiator is now configured to connect to the iSCSI target.
Configuring an iSCSI Initiator in Windows
Use QConvergeConsole CLI to configure the iSCSI initiator for Windows.
To configure a Windows iSCSI initiator:
1.
Access the QConvergeConsole CLI either by double-clicking the
QCC CLI
desktop icon or by entering
qaucli
in the CMD window.
2.
On the QConvergeConsole CLI Main Menu, select
2, Adapter
Configuration
.
3.
On the Adapter Type Configuration Selection menu, select
1, CNA
Configuration
.
4.
On the Converged Network Adapter (CNA) Protocol Type Selection menu,
select
1, CNA iSCSI Configuration
.
5.
On the Converged Network Adapter (CNA) iSCSI Configuration menu,
select
3, Port IP Settings
.