Qlogic 3200 Series User Manual - page 59
2–Configuring NIC
QLogic Device Windows Property Pages
SN0054671-00 B
2-13
Configuring NIC Driver Parameters with QCC GUI
Refer to the
QConvergeConsole Help System: Setting General NIC Port
Parameters and Setting Advanced NIC Port Parameters
for information.
TCP Checksum Offload IPv4
Enables and disables the TCP transmit and receive
checksum offload.
Registry Key: *
TCPChecksumOffloadIPv4
Default:
Rx and Tx Enabled
Values:
Disabled, Rx Enabled, Tx Enabled,
Rx
and
Tx Enabled
TCP Checksum Offload IPv6
Enables and disables the TCP transmit and receive
checksum offload.
Registry Key: *
TCPChecksumOffloadIPv6
Default:
Rx and Tx Enabled
Values:
Disabled, Rx Enabled, Tx Enabled,
Rx and Tx Enable
d
UDP Checksum Offload IPv4
Enables and the disables the user datagram protocol
(UDP) transmit and receive checksum offload.
Registry Key: *
UDPChecksumOffloadIPv4
Default:
Rx and Tx Enabled
Values:
Disabled, Rx Enabled, Tx Enabled,
Rx and Tx Enabled
UDP Checksum Offload IPv6
Enables and disables the UDP transmit and receive
checksum offload.
Registry Key: *
UDPChecksumOffloadIPv6
Default:
Rx and Tx Enabled
Values:
Disabled, Rx Enabled, Tx Enabled,
Rx
and
Tx Enabled
VLAN ID for Setting
If the Priority and VLAN Tag is enabled, this parame-
ter specifies a VLAN ID for this interface (also
exposed through the standard object identifier (OID)).
Registry Key:
VlanId
Default:
0 (no VLAN)
Range:
0-4094
Table 2-1. Windows Driver Configurable Parameters (Continued)
Property
Description