Qlogic 3200 Series User Manual - page 139
3–Configuring iSCSI
iSCSI Initiator
SN0054671-00 B
3-5
6.
Select the Converged Network Port you want to configure.
7.
Select
2, Configure IP Settings
.
8.
Complete the interactive list of settings as follows:
a.
Enable IPv4 [on]:
Press the ENTER key to accept the default.
b.
DHCP to obtain IPv4 Network Information: [off]:
Press
the ENTER key to accept the default.
c.
IP_Address []:
Type the IP address of the initiator system, and
then press the ENTER key.
d.
IP_Subnet_Mask [255.255.255.0]:
Type the appropriate
subnet mask, and then press the ENTER key.
e.
IP_Gateway [0.0.0.0]:
Press the ENTER key to accept the
default.
f.
Enable IPv6 [off]:
Press the ENTER key to accept the default.
9.
On the options menu that opens, select
3, Save changes and reset HBA (if
necessary)
.
10. At the prompt for both ports, type
Yes
.
11.
To return to the Converged Network Adapter (CNA) iSCSI Configuration
menu, type
p
and press the ENTER key, and then type
p
and press the
ENTER key again.
12. On the Converged Network Adapter (CNA) iSCSI Configuration menu,
select
4, Target Configuration
.
13. Select the same Converged Network Port you selected in
14. Select
6, Add a Target
.
15. Complete the interactive list of settings as follows:
a.
IPv6 Target? [off]:
Press the ENTER key to accept the default.
b.
TGT_iSCSI_Name []:
Type the iSCSI qualified name (IQN) of the
iSCSI target to connect to, and then press the ENTER key.
c.
TGT_Port [3260]:
Press the ENTER key to accept the default.
d.
TGT_TargetIPAddress [0.0.0.0]:
Type the IP address of the
target, and then press the ENTER key.
16. On the options menu that appears, select
12, Save Target/CHAP Changes
.
The iSCSI initiator is now configured to connect to the iSCSI target.