QMS 1660 Operation - page 63
Clearing Media
Jams
6-7
Troubleshooting
1
Open the front upper door and remove the jam by pulling in
the direction of the arrow.
2
After removing the jammed print media, close the front
upper door.
If the jam has been cleared, printing will restart.
If you can’t easily remove the print media from the front upper
door area, remove the jam from the front inside area, as
described earlier in the “Clearing Front Inside Area Jams” section
of this chapter.
Clearing Multipurpose Tray Area Jams
»
Note:
Leaving print media in the multipurpose tray can cause the
print media position to shift during removal of the jam. This may result
in a media feed failure and another jam when printing is restarted.
1
Using both hands, open the multipurpose tray.
2
Remove all print media remaining in the multipurpose tray
and close the tray extension.
3
Push up on the front cover release button, and open the
front cover.
Front Upper Door