Tait TP9300 User Manual - Charging The Battery
114 Charging and caring for batteries
You should recharge or replace the battery as soon as
possible. When the battery is completely empty, the
message
Battery is flat
appears on the display. The
radio emits a long, low-pitched beep and then stops
working. Turn off the radio immediately.
Charging the battery
Fully charge a battery before using it for the first time.
This will take up to 2.5 hours.
The red LED stays lit while the battery charges.
To charge the battery:
1
Desktop charger: Connect the charger to the
correct Tait power adaptor.
Multicharger and vehicle charger: Power on the
charger.
Initially, all three LEDs are lit for two seconds.
2
Place just a battery in the charger, or a radio with
a battery attached (desktop charger or
multicharger only). There is no need to remove a
belt clip, antenna, or any accessory that is
attached to the accessory connector.
The red LED lights up, and stays lit while the
battery charges. For a battery that is almost
completely discharged, allow two hours.
When charging is complete, the green LED
stays
lit.