Tait TP9300 User Manual - Led Behavior
Charging and caring for batteries 115
LED behavior
If there is a battery in the charger when power is
supplied to the charger, the LEDs behave as follows:
If the charger does not behave as expected:
■
Make sure the radio or battery is seated properly
in the charger.
■
Check that the charger is properly plugged in.
■
Check that the battery and charger contacts are
clean. To clean, wipe the contacts with a dry lint-
free cloth to remove any dirt, oil or grease.
Removing the battery from the charger
■
Desktop charger and multicharger: Lift the bat-
tery/radio out of the charger.
■
Vehicle charger: Pull the release bar up, and then
lift out the battery.
LED Meaning
briefly
The charger has been connected to a power
supply.
steady
The battery is charging.
steady
Charging complete. Remove the battery,
or leave it in the charger.
steady
■
The battery temperature is outside the
normal charging range. Charging will start
or resume once the temperature is within
normal limits. No action is required.
■
There is a fault. Contact your local
regional Tait office.
all off
There is a fault. Contact your local
regional Tait office.