Tait TP9300 User Manual - A Call
90 Operating in conventional mode
Using the function key programmed for reset
monitor / call cleardown to end active calls
The function key programmed for reset monitor may
be programmed so that a short key press ends your
current call, and a long key press ends all active calls
in your group.
Activating the repeater before
a call
A repeater-access tone is sent to activate the repeater
before a call is made, so that the start of the call is not
lost.
To send a repeater-access tone, you may be able to
either use the PTT key, or use a programmed
function key.
Using the PTT key
1
Press the PTT key and the repeater-access tone
for the current channel is sent.
The call details appear in the display, the LED
glows red, and appears in the display. You may
also hear signaling tones.
2
Press and hold the PTT and proceed with your call.
Using a function key
1
Press the function key programmed for sending a
repeater-access tone, and the repeater-access
tone for the current channel is sent.
The call details appear in the display, the LED
glows red, and appears in the display. You may
also hear signaling tones.
2
Press and hold the PTT and proceed with your call.