Tait TP9400 User Manual - Charging The Battery
122 Charging and caring for batteries
Charging the battery
Fully charge a battery before using it for the first time.
This will take up to 2.5 hours.
The red LED stays lit while the battery charges.
To charge the battery:
1
Desktop charger: Connect the charger to the correct
Tait power adaptor.
Multicharger and vehicle charger: Power on the
charger.
Initially, all three LEDs are lit for two seconds.
2
Place just a battery in the charger, or a radio with a
battery attached (desktop charger or multicharger
only). There is no need to remove a belt clip, antenna,
or any accessory that is attached to the accessory
connector.
The red LED lights up, and stays lit while the battery
charges. For a battery that is almost completely
discharged, allow two hours.
When charging is complete, the green LED
stays lit.