Tait TP9400 User Manual - Removing The Battery

 Before using your radio  27

Removing the battery

The battery is secured to the radio by a battery catch in 

the radio’s rear panel.

To remove the battery from the radio, so that the battery 

can be charged or replaced:

1

Slide the battery catch up.

2

From the sides, pull the battery away from the radio.

Attaching the antenna

Before using the radio, screw the antenna clockwise into 

the antenna connector. The antenna should be screwed 

sufficiently tight so that it doesn’t unscrew easily.

Before using the radio, screw the antenna clockwise 

into the antenna connector. The antenna should be 

screwed sufficiently tight so that it does not unscrew 

easily. This is important as it creates a seal.

Removing the antenna

Use a firm grip and turn the antenna counterclockwise 

half a turn. Use a lighter grip to fully unscrew the 

antenna, and carefully remove it.

Attaching a belt clip

To attach a belt clip to the radio:

1

Slide the belt clip into the two grooves at the top of 

the battery.

2

Press down on the belt clip until it snaps into place.