Tait TP9400 User Manual - Removing A Belt Clip

28  Before using your radio

Removing a belt clip

The belt clip has been designed to prevent accidental 

removal, but you can take it off, if required.

To remove a belt clip from a battery:

1

Insert a flat screwdriver blade or similar flat object 

under the lip of the release lock (that is, between it 

and the metal slider).

2

Lift the release lock up (away from the metal slider) 

and hold it in position.

3

Slide the belt clip out.

Installing an accessory

Accessories plug into the radio’s accessory connector. 

The accessory connector is protected by a cover, which 

needs to be removed before an accessory can be 

installed.

Notice  The accessory cover protects the accessory 

connector from electrostatic discharge. Keep the cover 

in place unless the connector is in use.

To remove the accessory cover and install an accessory:

1

Use a coin or other blunt object to loosen the screw 

that secures the accessory cover to the radio.

2

Remove the accessory cover and store it in a safe 

place.

3

Plug the accessory into the accessory connector.

4

Tighten the screw.