TallyGenicom 6306 Maintenance Manual - page 33
Chapter 2. Menu Operations
27
2.3.2 Fault Override Category
This category provides you with a means of controlling fault reporting from the Engine Manager
to the Control Processor. Each of the following parameters has two selections: OFF and ON.
When these parameters are set to OFF, faults are reported as they happen (Fault Override is
disabled). When these parameters are set to ON, faults are not reported on the display (Fault
Override is Enabled).
2.3.2.1 Paper Out
This parameter provides fault override for Paper Out Faults.
2.3.2.2 Shuttle
This parameter provides fault override for Shuttle Fault reporting.
2.3.2.3 Temp
The Temp Parameter provides fault override for Temperature Threshold fault reporting.
2.3.2.4 Control
This parameter provides fault override for the control processor fault reporting status.
2.3.2.5 Link
This parameter provides fault override for control processor to main processor communications.
2.3.2.6 Sync
This parameter provides fault override for the "Lost Sync (28)" error in Twinax Interface Mode.
Check printer cable connection.