TallyGenicom 6306 Maintenance Manual - page 68
Other manuals for 6306:
Quick Start Manual, Specifications, Operator's Manual, Operator's Manual, Installation Instructions Manual, Brochure, Specifications
of
175
6300 Series Maintenance Manual
62
9. Unthread the round shaft from the Vernier Knob by turning the knob and holding the
shaft in position. (There is a ground wire that is hard-mounted to the left end of the
shaft.) Slide the round shaft as far left as possible
Unthread shaft
10. You should now be able to lift the square and round shafts together slightly and slide
the tractors to the right and off of the shafts
When remounting the tractors, pay attention that the timing marks on the tractor bearing
that fits on the square shaft are both on the same “lobe” of the square shaft.