Vega VEGAPULS 69 Operating Instructions Manual - 4 Mounting
7
4 Mounting
Process assembly • VEGAPULS 69
50714-EN-150903
4 Mounting
4.1 Mounting preparations
The following tools are required for dismounting the existing and
mounting the new process component:
•
Torx screwdriver, size T 10
•
Flat-headed screwdriver, size 4
•
Screwdriver for recessed head screws, size 1
•
pliers for locking ring (version axle)
4.2 Dismounting steps previous process
component
First of all the electronics module is dismounted and the housing
removed.
The electronics module is located in the electronics compartment.
The below illustrations show the respective position of the electronics
compartment in a single or double chamber housing.
1
Fig. 2: Single chamber housing
1 Position of the electronics compartment
1
Fig. 3: Double chamber housing
1 Position of the electronics compartment
Proceed as follows:
1. Switchoffpowersupply
2. Unscrew the lid of the electronics compartment
3. Disconnect the connection cables according to the operating
instructions manual of the respective sensor
4. Loosen the two holding screws with the screwdriver (Torx size
T 10 or slotted screwdriver size 4)
Tools
Dismounting the elec-
tronics module