Verint Nextiva S1100w User Manual - Data
3: Configuring and Installing the Device
18
Verint Video Solutions
Cable for Power, Video, and Serial
Data
The supplied CAB9P cable assembly is used for video, power, and serial port connection.
For the detailed pinout, see page 46.
Serial Port
The S1100w integrates one multipurpose serial port. This port is used for system
configuration and data communication: pan-tilt-zoom (PTZ), access control, or other. By
default, the port automatically detects if it is connected to an RS-232 or RS-422/485 serial
device.
The CAB9Pcable is supplied with a female DB-9 plug enabling RS-232 connections.
However, most PTZ cameras, keyboards, and similar devices use RS-422/485 connections.
Therefore, you will have to adapt the CAB9P cable for its different uses:
During the configuration process of the S1100w, you need to access a computer, so the
DB-9 connector is required for RS-232 communication.
Later, when installing the device in its final location, you will likely want to connect it to
RS-422/485 equipment, therefore requiring changes on the cable. You should keep the
DB-9 connector on the cable for later use.
Warning: At any time there must be only one serial device connected to the S1100w
device. For instance, when configuring the device, you must unplug any
RS-422/485 device.
Power
Use the red and black wire pair of the CAB9P cable to connect the S1100w device to an
external power supply.
Mating connector
DB-9 connector
Terminal block
Power wires
BNC video connector