Verint Nextiva S1100w User Manual - page 37
Verint Video Solutions
21
Nextiva S1100w User Guide
To perform a point-to-point connection:
1. Start SConfigurator.
2. In the Units tab, discover the desired devices.
The discovered devices appear in the Units box.
3. Select the Connections tab, then click Add.
The Connection Creator window appears.
4. Select a transmitter in the left column and a receiver in the right one.
In the Transmitters column, you have access to the two encoders of each input; the
video stream is the same for both.
5. In the Video list, select the desired video mode.
6. To disable I/O data transmission (for example, alarms) between the two selected
devices, clear Forward I/O.
7. To disable serial port data transmission (like PTZ commands), clear Forward Serial
Port Data.
8. To enable audio between the devices, ensure that Enable Audio is checked, then select
the audio mode.
9. Click Connect.
You should now have video on the monitor connected to the receiver.
Installing the Wireless System
After configuring successfully your wireless system, you are ready to install it. To optimize
your system radio performance, carefully review the site planning information presented in
Chapter 2 on page 5. For more information about the installation procedure of your outdoor
wireless bridge, refer to the Nextiva S3100 User Guide.