Verint Nextiva S1100w User Manual - Setting The Vsip Port
Verint Video Solutions
41
Nextiva S1100w User Guide
Setting the VSIP Port
The VSIP port (accessible through the VSIP menu) is a communication port used for
protocol messaging between your computer and Nextiva devices. The default VSIP port of
all devices is 5510.
Note: VSIP ports 9541, 65500, and those under 1024 are reserved and should not be used,
not even for serial port, video, or audio communication. The maximum value is
65535.
Load Default Configuration
The Load Default Configuration command, located in the main menu, resets all device
parameters to their factory settings (described in Appendix A on page 43). All user-defined
values will be lost. To reset the parameters to their factory defaults with a hardware
operation instead, see page 27.
Following a reset, you will need to reprogram the S1100w device (for instance, its IP
address and VSIP port) for proper operation within its network.
Reboot System
The Reboot System command, located in the main menu, performs a soft boot on the
S1100w. A system reboot clears all unsaved changes in the CLI and returns to your preset
configuration.