Wacker Neuson LTV6K Operator's manual - Machine Setup
wc_tx004430gb_FM10.fm
48
Machine Setup
LTV
4.10
Raising the Tower—Power Winch System
Background
The Light Tower includes a telescoping winch for raising the tower.
Requirements
■ Machine is shut down
■ Light Tower is located on a firm, flat surface clear of overhead wires and
obstructions
■ Winch cables are in serviceable condition and resting properly in pulleys
■ Light Tower has been leveled, with all outriggers extended and locked
This procedure continues on the next page.
WARNING
Electric shock hazard! Do not use the machine if insulation on any of the electrical
cords is cut or worn through. Bare wires in contact with the metal frame of the trailer
or tower can cause electrocution.
► Repair or replace the cord before using the machine.
WARNING
Electrocution hazard.
► Do not position the Light Tower under electrical power lines.
WARNING
Tipping/falling hazards. Certain actions may cause the tower to fall or the machine
to tip over.
► Do not raise the tower or operate the Light Tower in high winds.
► Do not pull the vertical tower locking pinwhile the tower is raised.
WARNING
Personal injury hazard. Bystanders can be struck by the tower as it is being raised.
► Do not allow anyone to stand near the front of the machine while raising the
tower.