Wacker Neuson LTV6K Operator's manual - Machine Setup
Manual is about: Light Tower
60 Hz
of
110
wc_tx004430gb_FM10.fm
50
Machine Setup
LTV
4.11
Lowering the Tower—Power Winch System
Requirements
■ Lights are turned off
■ Engine is stopped
■ Outriggers are extended and locked in place
Procedure
Perform the procedure below to lower the tower.
1. Hold the rotary switch (b) in the down position (“cable out” direction) until the
tower is completely lowered.
This procedure continues on the next page.
WARNING
Tipping/falling hazards. Certain actions may cause the tower to fall or the machine
to tip over.
WARNING
Personal injury hazard. Bystanders can be struck by the tower as it is being raised
or lowered.
► Do not allow anyone to stand near the front of the machine while raising or
lowering the tower.
wc_gr013773
a
b