WEG CFW700 User Manual - page 32
CFW700 | 27
Keypad (HMI) and Basic Programming
E
ng
lis
h
NOTE!
It is necessary to set the password at P0000 for parameter modification.
Otherwise the parameters contents can only be viewed.
The default password for P0000 is 5. It is possible to change the password at
P0200. Refer to the CFW700 programming manual.
Inverter status
Local/Remote
(commands and
references source)
Secondary display
Variable unit
(shows the value of
the main display)
Variable monitoring
bar graph
Menu (parameters
group selection) –
only one parameter
group is shown at
each time.
Main display
Motor rotation
Figure 4.2: Display sections
Parameter groups available at the Menu:
PARAM: all parameters.
READ: only the reading parameters.
MODIF: only the parameters changed compared to the factory default.
BASIC: basic application parameters.
MOTOR: parameters related to motor data control.
I/O: parameters related to the digital and analog inputs/outputs.
NET: parameters related to the communication protocol.
HMI: parameters for the keypad configuration.
SPLC: parameters related to the SoftPLC function.
STARTUP: parameters for the Oriented Start-up.