WEG CFW700 User Manual - page 55
50 | CFW700
E
ng
lis
h
First Time Power-Up and Start-Up
Step
Action/Display Indication
Step
Action/Display Indication
11
12
If necessary, change
“P0398 – Motor
Service Factor” parameter. This change
will affect the current and the time of the
motor overload protection operation.
Press the
key to the next parameter.
If necessary, change
“P0400 – Motor
Rated Voltage” parameter. This change
corrects the output voltage by the factor
“x = P0400/P0296”.
Press the
key to the next parameter.
13
14
If necessary, change
“P0401 – Motor
Rated Current” parameter. This change
will affect P0156, P0157, P0158 and P0410.
Press the
key to the next parameter.
If necessary, change
“P0404 – Motor
Rated Power” parameter. This change
will affect P0410.
Press the
key to the next parameter.
15
16
If necessary, change
“P0403 – Motor
Rated Frequency” parameter. This
change will affect P0402.
Press the
key to the next parameter.
If necessary, change
“P0402 – Motor
Rated Speed”. This change will affect
P0122 to P0131, P0133, P0134, P0135,
P0182, P0208, P0288 and P0289.
Press the
key to the next parameter.
17
18
If necessary, change
“P0405 – Encoder
Pulse Number” according to the encoder
model.
Press the
key to the next parameter.
If necessary, change
“P0406 – Motor
Ventilation” parameter.
Press the
key to the next parameter.
The parameters to come after selecting
P0406 may vary according to the type of
control set at P0202.
19
20
If necessary, change
“P0408 – Run Self-
Tuning” parameter.
Press the
key to the next parameter.
Run the self-tuning when running in V V W
and vector modes.
Press the
BACK/ESC key to end the
oriented start-up routine.
Press the
BACK/ESC again to go back to
the monitoring mode.
Figure 5.1: Oriented Start-up