WEICHAI WD10 Service Manual - page 28
of
163
Service Manual for WD10 Diesel Engine
18
Fig. 2-11 Deflating of coarse filter
Drain water in water collector:
ATTENTION: When water collector is full or spinning coarse filter is replaced, it is required
to drain the water in water collector out.
Draining steps (as shown in Fig. 2-12):
Open the oil drain plug 2 on bottom of water collector1 to drain all water out.
Retighten the plug.
Fig. 2-12 Drain water in water collector
Replace water collector:
Replacing steps (as shown in Fig. 2-13):
Shut down the engine.
Drain water in water collector.
If possible, remove screw 1 on water collector with hand. If it’s too tight, use a handling tool.
Apply some lubricating oil on the new collector sealing ring 2.