WEICHAI WD10 Service Manual - page 53
Service Manual for WD10 Diesel Engine
43
4254 Steps to Assemble Hanger Plates
Firstly distinguish the front hanger plate and rear hanger plate, front hanger plate should be installed
on front end of engine (fan end), and rear hanger plate should be installed on rear end of engine
(flywheel end), fasten the plates with M12 hexagon bolts (as shown in Fig. 4-6), required tightening
torque is 100~125Nm.
426 Disassembly, Inspection, Maintenance and Assembly of Cylinder
Cover
4261 Exploded View of Cylinder Cover
Cylinder cover main
bolt
Nut
Cylinder block
Cylinder cover
Clamp block
Cylinder cover gasket
Clamp block
Cylinder cover auxiliary
bolt
Fig. 4-7 Exploded view of cylinder cover
4262 Steps to Disassemble Cylinder Cover
Before removing the cylinder cover, it is required to remove the parts that are installed on cylinder
cover first, including: intake pipe and exhaust pipe (refer to 46 Intake and Exhaust System for
details), fuel pipes and wiring harnesses (refer to 47 Fuel system for details), cylinder cover shield,
oil-gas separator, water outlet pipe and hanger plates (refer to 42 Cylinder Cover Assembly for