WEICHAI WD10 Service Manual - page 66
Service Manual for WD10 Diesel Engine
56
433 Disassembly, Inspection, Maintenance and Assembly of Engine Front
Cover
4331 Exploded View of Engine Front Cover
Engine front cover
Seal ring
Hexagon flange toothed bolt
Fig. 4-22 Exploded view of engine front cover
4332 Steps to Disassemble Engine Front Cover
(1) Remove engine front cover fastening bolts (key point 1);
(2) Remove engine front cover (key point 2);
(3) Remove engine front cover seal ring (key point 3);
4333 Inspection and Maintenance of Engine Front Cover
Key point 1: The removed engine front cover should be placed in clean environment, check and
ensure inner side of engine front cover is clean before assembling.
Key point 2: Apply sealant on the fitting surface of engine front cover, make sure the sealant is
evenly distributed and no discontinuity.
Key point 3: Check whether seal ring is damaged, replace it if so. When assembling, seal ring
should be fully pressed into engine front cover seal groove.